Creative Kitchens 7530 Serie Montageanleitung

(EN) ● ASSEMBLY MANUAL WIRESHELVING ● ASSEMBLY STEPS:
A B C
4 PCS 4 PCS 4 PCS
● Wheels and clamps are sold separately ● Clean the shelving with a damp cloth, if necessary with soap. After cleaning, dry the shelving thoroughly ● Do NOT move the shelving when loaded ●
①
Screw the levelling feet (E) into the bottom of the four lower
poles (B) Snap the plastic clips (D) into the pole grooves of the four
lower poles at the same position and make sure that the arrow on
the plastic clips is pointing up.
③
Snap the plastic clips into the pole grooves of the lower poles at
your desired shelf height/position. Slide down the shelf from top
down into the plastic clips.
⑤
D E
Repeat step 3 to assemble the rest of the wire shelves.
32 PCS 4 PCS
②
in the collar faced down). Hold the wire shelf on its side and slide the top of
the four lower poles through the bottom of each wire shelf as its corner until
it snug fits. After four poles have been slide through the shelf collar holes,
CAUTION!
set the shelf upright.
Arrow on the plastic clips
must point upwards
④
two parts together through the screw connectors which are already present
on the upper poles.
⑥
shelf at the corners with a rubber mallet to ensure the shelf is in place over
the plastic clips. Screw the levelling feet in or out to attain proper levelling.
Please make sure the wire shelf (A) is the correct way up (keep the gap
Keep the gap in collar facing down
Connect the upper poles (C) with the lower poles (B) by screwing the
Once all the shelves have been installed, pushing firmly down on every