Before Use; Intended Use - Aidapt Vm941 Gebrauchs- Und Wartungsanleitung

INTRODUCTION
Thank you for deciding to purchase the Plastic Handled Button Hook Zipper from
Aidapt. The Plastic Handled Button Hook Zipper is manufactured from the finest
materials available. When used correctly it is designed to give many years of
reliable, trouble-free service.

BEFORE USE

Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.

INTENDED USE

A handy device for securing buttons and fastening zips, the Plastic Handled Button
Hook/Zipper has a loop at one end for buttons and a C hook at the other for zips. It
is ideal for people who have limited mobility or the use of only one hand.
The button loop hook simply passes through the button hole and clips around the
button which can then be pulled through.
The C hook for zips slips into the tab of the zip and provides a comfortable grip to
pull the zip up or down as required.
INSTRUCTIONS FOR USE
Button Hook:
Grip the plastic handle with the hand on the same side as the button hole
•
Pass the stainless steel loop through the button hole towards the button
•
Position the widest part of the steel loop over the button and move it to
•
the side so that the narrow point of the steel loop is directly below the
button, around the securing thread
Pull the plastic handle back so that the steel loop passes back through the
•
button hole, with the button still in the steel loop
Gently push the steel loop forward so that the widest part of the loop is
•
below the button and then lift it up and over, leaving the button in the
button hole.
Button Hook:
Slip the C Hook into the zip tab and use the handle to move the zip up or
•
down
Usage and Maintenance Instructions
2
Ver. 2 08/2012 (2175)