Inhaltszusammenfassung für AquaCare Ultra Pure MB001PP
Seite 1
15 µS/cm. Bei schlechterer Qualität steigt die Leitfähigkeit des Reinstwasser schneller bei besserer Qualität langsamer. GB: The produced water quality of the AquaCare 10” ultra pure water filter. Inlet water with R.O. technique 15 µS/cm. If the inlet water is of a worse qual- ity the capacity is lower, if better the capacity is higher.
Seite 2
Entfernen Sie das verbraucht Harz und füllen schlossen werden. Das von AquaCare verwendete Reinstwasserharz nun frisches AquaCare Reinstwasserharz bis ca. 2 cm unter die O- ist ein Einwegharz und muss nach der Beladung mit Salzen ausge- berkante. Stecken Sie den Schwamm und das Filtersieb wieder hin- tauscht werden.
Seite 3
The filter grid and the sponge must be removed. Important! If the feed water with a conductivity of more than 100 Remove the use resin and fill now fresh AquaCare ultra pure water µS/cm is used, the silicic acid rejection cannot be ensured. In this resin to approx.