Raychem FrostGuard-ECO Montageanleitung Seite 6

English
The FrostGuard-ECO controller (230 V) provides temperature
and energy control for the Raychem FrostGuard heating
cable kits for pipe freeze protection.
The controller includes an external sensor and cable which
can be placed on the pipe (under the insulation) or can
operate as an ambient temperature sensor to switch the
control unit on and off.
Installation steps (see page 5):
Attach sensor cable to pipe on the opposite side to the
A
FrostGuard heater.
Cover the sensor and heater cable with correctly sized
B
insulation
Plug FrostGuard-ECO into the electrical supply socket.
C
Plug the FrostGuard heater kit into the front of the
FrostGuard-ECO control. Set the desired switching
temperature on the front of the unit.
This product is to be powered from an electrical supply
with RCD electrical protection. In order to provide energy
efficiency and freeze prevention, Tyco Thermal Controls
recommends a standard set point temperature of 3°C.
6