Bailey 146948 Bedienungsanleitung

Emergency Power Supply for LED Rope Plus
INSTALLATION MANUAL | HANDLEIDING | ANLEITUNG | MANUEL
EN - INSTRUCTIONS
Before installation please read the specifications to make sure
that this product is suitable for the operating environment.
• Thanks to the clever connection system, the emergency
power supply is compatible with various versions of the LED
Rope Plus series.
• When a power failure occurs, the module automatically
switches to battery mode and provides lighting at 30% of its
normal brightness.
• With a fully charged battery, it offers 2 hours of emergency
lighting.
• Once reconnected to mains power, the battery recharges
automatically.
• Press the on/off button for 3 seconds to stop emergency
function.
Technical specifications
Input voltage
Output voltage
Maximum connectable power
Maximum emergency power
Starting emergency power
Emergency time
Battery charge time
Input cable
Output cable
Housing dimensions
IP rating
Operating temperature range
Charging
• A built-in LED indicator shows the battery status.
• Indicator light will be green colour if charged over 90%,
below 90% it will be red.
• Press the on/off button to check remaining electricity
capacity. If indicator light flashes:
Indicator Remaining
light flashing capacity
1x < 20%
2x 20~40%
3x 40~60%
4x 60~80%
5x > 80%
Warnings - Safety - Caution
• Risk of electric shock. Disconnect power before installation,
servicing and removal.
• Make sure the supply voltage is the same as the input
voltage.
• All safety instruction must be followed to avoid a risk of injury
or property damage.
• Suitable for indoor and outdoor use.
• Not suitable for use in extreme conditions or locations
involving harmful substances.
• Do not cover the product. Do not attach other items to the
product. Store and install the product out of the reach of
children. Only use the product when it is working perfectly.
Bailey Electric & Electronics bv - Everdenberg 21 - 4902TT Oosterhout - The Netherlands - +31 (0)162 52 2446 - www.bailey.nl
AC 220-240V ≤7A
DC 170-175V
1200W
50W
20W Min
120 min
24h
1.2M 2*1.5mm²
1.2M 2*1.5mm²
285x90x50mm
IP65
-10~50°C
• Do not touch the product in the event of a fault or
breakdown. Immediately switch off the product and
disconnect the power supply.
• The following situations are meant by fault or breakdown:
there is visible damage to the product, the product is not
working, there is a burning smell, the results of overheating
are visible.
• Testing and small repairs must be carried out by a qualified
electrician.
Disposal
Electrical products may not be disposed of in the same way as
normal household waste. Take the table lamp to a place where
it can be recycled. Consult the local authorities or the seller for
advice about collection and processing.
Warranty
The warranty period will begin on the day on which the product
was purchased from Bailey and will end after 2 years. If a defect
occurs within the warranty period as a consequence of material
faults and/or manufacturing errors, Bailey will replace the
product. The warranty does not cover consequential damage,
nor will any call-out charges, transport costs or installation costs
be reimbursed. The warranty does not apply if:
• There is no information, or there are no documents, referring
to the date of purchase (invoice or delivery note).
• The model and/or serial number located on the product is
unrecognizable (include photo of product sticker or imprint
with specifications).
• The defect was caused by improper use of the product or
use not as intended, or by use in extreme conditions or in
conditions involving harmful substances.
• Damage to the product was caused by external factors.
• The product is modified.