Juniper DX 3200 SERIE Schnellstartanleitung Seite 3

• At each prompt, enter the requested information and press Enter.
Required
— IP address of the Ether0 port on the DX device (such as "172.17.0.2").
— Subnet mask for the IP address (such as "255.255.0.0").
— Fully-qualified host name for the DX device (such as "dx.juniper.net").
— DNS domain (the "domain suffix") where the DX device is installed (such as "juniper.net").
— IP address of the primary DNS server.
— IP address of the gateway used for the default route.
Optional (press Enter to define later)
— Enter "y" or "n" to enable or disable Web access to the DX device. If you enable the Web interface, you are prompted
for the port number. To use the Web interface, enter the Ether0 address and the specified port in your browser
(such as "http://192.168.4.76:8090").
— For the last two prompts, enter "y" or "n" to enable or disable Secure Shell (SSH) and Telnet access to the
DX device.
• After the last prompt, you should see the following:
Writing configuration.
Done.
hostname%
The command line prompt is the first part of the DX domain name followed by a "%" sign.
• For security reasons, enter the following command to change the default password for the "admin" account.
hostname% set password
If you forget the password, you can press and hold the password reset button on the back panel for five seconds
to restore the default value.
Connect the network cables.
™
To connect the network cables:
• DX 32xx — Connect an Ethernet cable from the Ether0 port on the DX device switch port set to 100BaseTX and full-
duplex. DO NOT use autoselect on either port.
DX 36xx — Connect an Ethernet cable from the Ether0 port on the DX device to a Gigabit switch port set to 1000BaseTX.
•
Use autoselect only for fiber-optic ports.
DX 32xx and DX 36xx QUICK START