SmartLab ALU extended mount Installationsanleitung Seite 2

Installation guide
Step 1
First choose which bike computer you want
to use. GAM for smartLAB, Garmin and many
others. BRT look for Bryton,
Step 4
Choose the right rubber pad depending on
your handlebar diameter.
Step 7
Place the cycle computer sideways in the
holder and turn it 90 °.
Installation of the additional bracket for other devices such as camera or light
Step 1
Screw the suspension to the lower part of
the handlebar bracket with 2 small screws.
Step 2
Take 2 small screws and screw the fastening
piece so that the designation (GAM) is
vertical.
Step 5
Attach the handlebar bracket to the rubber
pad and tighten the large screw.
Step 8
The bicycle handlebar bracket and computer
is fully assembled.
Step 2
Slide the light bracket (included) or camera
bracket into the suspension.
ENGLISH ENGLISH
Step 3
Screw the handlebar bracket to the moun-
ting kit with the 2 large screws. Do not fully
tighten the screws. That only happens on
the bike.
Step 6
Bring the handlebar bracket into the desi-
red position and tighten the 2 screws.
Step 3
Push the large screw with the handle into
the round guides and screw it tight after
you have mounted the handlebar bracket
on the bike.