Installing Cinema Pro In Vehicle - Nextbase Cinema Pro Schnellstartanleitung

Installing Cinema Pro in Vehicle

This device is specifically designed to be mounted behind the driver and/or
passenger seat(s).
1 Remove the headrest(s) and carefully route the
cable(s).
For Uno Cinema Pro
Route the T-cable into the hole of the pole on
the seat.
For Duo Cinema Pro
Route the T-cable 2 and T-cable 3 into the holes
of the poles on each side of the seat. Then from
the bottom of the seat, connect both ends of
the T-cable 2 and T-cable 3 to the T-cable 1
connectors.
2 Replace the headrest(s) into place.
3 Remove the screws to release both locking
latches on the stanchion mount.
4 Position the bracket on the bars of the headrest.
Fasten the screws on both locking latches to fix
the bracket firmly on the bars.