Bergstrom P835 Anleitung

Wireless Charging Alarm Clock
Item No:
P835 / 717060
Instructions for Use
Please read and retain these instructions for future reference
Power Details:
Accessories:
Note: This item is powered by its USB cable. It requires power from a USB Charger (sold separately) to be used. (This
should be of 5V / 500mA). The included button cell battery will ensure the unit retains its memory (time, date and
alarms) should there be a power cut – but will not display this until powered again. It will not charge your phone when
the unit is not powered externally itself.
Please read this instruction manual thoroughly before starting and ensure you are familiar with the
operation of your new Wireless charging alarm clock.
Instructions for Use
For optimum performance, remove phone case and ensure an adequate power supply (we recommend using a dedicated
USB Wall Charger)
Any button on the back turns the alarm off, or alternatively it will automatically stop after 1 minute.
A quick press of the 'Set' button on the rear will switch between the display showing Time & Temp, or alternating
between Time & Temp, and Date.
Setup Mode
To enter setup, press the 'Set' button for 3 seconds.
Initially it will flash the year. Use 'Up' and 'Down' to adjust, before pressing 'Set' again to move to the next option. These
are in this order: Year, Month, Date, 24/12H, Hour, Minute.
After this, it will enter the Alarm setup mode (Three separate alarms are available) . Follow the same process as above to
amend these.
NB: It will initially be set as: 24-hour; January 1, 2016; 12H
When not in Setup mode
Pressing 'Up' for a short period changes the display from Centigrade to Fahrenheit
Press 'Down' changes to the display being off. The unit will then show its display for 15 seconds when tapped or
subjected to a loud noise (such as a heavy clap).
Lighting levels are automatically reduced between 18:00 and 07:00. To amend the light level, press the 'Up' button for 3
Seconds then the 'Down' button to select the required light level. Use 'Up' and 'Down' to change between the Four
different levels: L0 (off) or L1 – L3. Press the 'Up' key for 3 seconds to exit the setup.
v001: 26/06/25
ENGLISH INSTRUCTIONS
USB DC 5V
Battery Type & details: 2x LR1130 button cell included
Voltage details: 5V
Button Cell Compartment secured by
1 X USB CABLE
screw.