INSTRUCTION MANUAL ZIGBEE SMART PLUG 6705 – POWER METER + DIMMER
IMPORTANT!
• This dimmable smart plug can only be used with dimmable lighting
• Cannot be used with LED strips or in combination with other dimmers
• A Zigbee hub is required for operation via an app
• The energy measurement function is not available in all smart home apps or requires a subscription
This Zigbee smart plug power meter + dimmer (
• 10-150W LED
• 10-150W Filament LED
• 10-200W Incandescent / 230V Halogen
CHARACTERISCTICS OF THIS SMART PLUG POWER METER + DIMMER
•
2-in-1 solution: dim your lights and monitor energy use *
The dimmer has a soft start for a favorable influence on the life span of the applied LED lamps
•
Memory of last dim setting
•
On/off and brightness control via app or manually via the push button on the side of the smart plug
•
CONNECTING THE DIMMER
FACTORY RESET
It is recommended to reset the smart plug to factory settings before connecting it to a Zigbee network
•
To do this, connect a lamp to the plug and switch both on. Press the button three times quickly and hold it down for at
•
least two seconds the third time. The lamp will flash twice
PAIRING WITH A ZIGBEE NETWORK
•
Connect a lamp to the plug and turn both on. Press the button 6 times quickly. The lamp will flash 3 times to indicate
that the smart plug is in pairing mode.
•
Once in pairing mode, you can add the smart plug to your Zigbee network by following the instructions in your smart
app.
USING THE DIMMER
MANUALY
•
Push the button (1) to turn the smart plug on and off
•
Push and hold button (1) of the smart plug to increase or
decrease brightness. Release for the desired brightness level
APP
•
consult the app manual
* The energy measurement function is not available in all smart home apps or requires a subscription
The manufacturer is not liable for damages caused by incorrect use or improper installation of the dimmer. The warranty period is 2 years from the date of
purchase, to be proved at the retailer by means of your purchase receipt. Version EN 1.0 (07/11/2025). Keep this manual for (re-)installation! TRADIM
220V-240VAC 50Hz, 10-200W/VA)
BV Aalsbergen 9, 6942 SE (NL) Didam www.tradim.nl
is suitable for dimming the following light sources:
1