Herunterladen
Teilen
Diese Seite drucken
  1. Anleitungen
  2. Marken
  3. Crosby Anleitungen
  4. Messgeräte
  5. SP BOLT
  6. Bedienungsanleitung

Crosby SP BOLT Bedienungsanleitung

Vorschau ausblenden
1
2
3
4
5
6
7

Quicklinks

Diese Anleitung herunterladen
BOLT
Bolt-on-line-tensiometer
Operating instructions
PLEASE NOTE THAT CROSBY STRAIGHTPOINT
ACCEPT NO RESPONSIBILITY FOR ANY ERRORS OR
OMISSIONS WITHIN THIS MANUAL
v1.00
Part No:
SU6674
loading

Verwandte Anleitungen für Crosby SP BOLT

Inhaltszusammenfassung für Crosby SP BOLT

  • Seite 1 BOLT Bolt-on-line-tensiometer Operating instructions PLEASE NOTE THAT CROSBY STRAIGHTPOINT ACCEPT NO RESPONSIBILITY FOR ANY ERRORS OR OMISSIONS WITHIN THIS MANUAL v1.00 Part No: SU6674...
  • Seite 2 Crosby Straightpoint Crosby Straightpoint 123 Proxima Park, Houghton Avenue, 123 Proxima Park, Houghton Avenue, Waterlooville, Hampshire PO7 3DU · UK Waterlooville, Hampshire PO7 3DU · UK Tel: +44(0)2392 484491 · straightpoint.com Tel: +44(0)2392 484491 · straightpoint.com SQS791 Issue 1 Registered in England No. 04375389 · VAT Registered No. 793 2451 14 SQS691 Issue 2 Registered in England No.

  • Seite 3: Einführung

    Index / Introduction Einführung ‘BOLT’ wird verwendet, um die Spannung an einem Drahtseil zu messen, indem das Gerät mit den beiden Bolzen an einem Drahtseil festgeklemmt wird. Sofern bei der Bestellung nicht anders angegeben, werden die BOLTs standardmäßig mit 32 mm Drahtseil auf 10 te WLL kalibriert.

  • Seite 4: Fitting Batteries

    Fitting batteries How to clamp a BOLT IN A SAFE AREA ONLY, remove the side cover of the BOLT using a flat blade screwdriver. Fit batteries and refit cover. BOLT can be used on a range of wire rope of diameters from 16-32mm. The BOLT may be connected to the Straightpoint SW-HHP ATEX handheld, in hazardous areas, or to our range of load monitoring software that is not covered in this manual.
  • Seite 5 How to clamp a BOLT cont. How to clamp a BOLT cont. Make sure the bolts are torqued up equally, the torque rating is provided on the calibration certificate. Note: It is important that the two bolts are tightened equally, if not it could show incorrect readings. Montage du BOLT (contd.) Assurez-vous que les vis sont serrées de manière égale, le couple nominal de serrage est indiqué...
  • Seite 6 Wire rope diameters When using a wire rope diameter different to the calibrated one, torque it until the rope is in contact with BOLT body and use a torque wrench to measure the torque value. The correct torque is achieved when the rope is in contact with the BOLT body. When this is the case, record that torque value.
  • Seite 7 Crosby Straightpoint 123 Proxima Park, Houghton Avenue, Waterlooville, Hampshire, PO9 3DU, UK · Tel: +44 (0)2392 484491 2801 Dawson Road, Tulsa, OK 74110 · USA · Tel: +1 (918) 834-4611...