Werbung
Verfügbare Sprachen
Verfügbare Sprachen
System Requirement
Microsoft Windows XP/Vista/7(32/64 Bit)
Mac OS x 10.4+
Package Content
Multi-Memory Internal Card Reader w/USB2.0
Installation Guide
Installation Screws
Installation
If in doubt about how to install the device correctly, please contact an expert or a specialist workshop and let
them do the installation! Improper installation damages the plug-in unit as well as your computer and all
connected devices.
Proceed with caution. Danger to life!
Switch off the computer in which the product is to be installed and all connected devices. Disconnect all
devices from the mains voltage and pull out the mains plug! Just turning off at the on/off switch is not enough!
Open your computer s housing and carefully remove the cover.
Look for a free 3.5 installation slot and remove the slot cover.
Often there is a metal shielding behind it, which has to be removed first. With some casings, you
have to unscrew this, with others you have to break it out carefully. Depending on the casing, you
may have to remove the entire front cover first.
Apart from the slot cover that is already mounted on the slot, the scope of delivery includes two more
front covers in different colours. Depending on the existing computer housing, the slot cover can
easily be replaced by another one. Now you can install Card Reader like a Floppy Disk Drive into
empty slot.
Connect the 9-pin USB plug to an internal USB port on the mainboard. It is imperative to observe the
correct orientation (see operating instructions for the mainboard) since a wrong connection may
damage both the mainboard and the electronics of the 3.5 plug-in unit, loss of warranty(refer to below
photo)!
Multi-Memory 3,5 Internal Card Reader w/USB 2.0
Model No.: 76635I
3
Installation Guide
v1.01
Werbung
