Finixa ILO 20 Bedienungsanleitung

www.finixa.com
ILO 20 APPLICATION - DIRECTION
FOR USE
1. TURN ON THE POWER:
Ensure the power is turned on.
2. SET TIMER:
Set the timer to the desired time and starting
time.
Press
Diodes
seconds rate starts to blink.
Use
the seconds value and confirm
with the
utes value starts to blink.
Use
the minutes value and confirm
with the
Remarks:
- Press button at any moment to cancel the setting.
- Hold the or to quickly increase or decrease
the settings values.
ADDITIONAL INSTRUCTIONS:
• Always turn off the oven when not in use.
• Don't use the oven as a storage cupboard, someone might forget and turn it on.
• Never leave the oven unattended while using it.
• Do regular checks of the plug and socket for burn marks, to make sure that your oven is always in
the best condition.
• Don't cover the holes, this will make the oven overheat.
• Make sure that the oven is always in a clean state, as contaminations can catch fire.
MANUAL
button for 2s.
& light up and
or buttons to set
key. Then the min-
or buttons to set
key. Diodes go off.
www.finixa.com
|
ILO 20 DRYING OVEN
SPECIFICATIONS:
Ceramic IR heater
LED lightning
Power supply
Cable length
3. PUT SAMPLES INSIDE THE OVEN:
Place up to 2 samples together inside the oven.
4. WAIT UNTIL TIMER IS DONE:
Wait until the timer is completed.
5. REMOVE SAMPLES:
Take the samples out of the oven.
6. TURN OFF POWER:
Ensure the power is turned off.
125W
230 V - 4W
250 V
1,5 m