Power Cable - JML Ultra Vac Gebrauchsanleitung

Using Your UV Ultra Vac
Power cable hook
Telescopic handle
20

Power cable

To release the power cable first pull and
lift the bottom power cable hook into the
2nd
upright position. Now slide the power cable
from its housing and unwind. When you are
finished using the appliance, lower the power
1st
cable hook into its original position, click
back into place and then proceed to wind-
up the power cable around both parts.
Telescopic handle
Release
To release the handle, first ensure the
button
appliance is on a level surface. Press the
release button, this is located at the rear in
the centre. You can either use your finger or
the power cable hook to release it. Now slide
the handle outwards until it is fully extended
and locks into place.
To close the handle, press the telescopic
handle button located on the left hand side of
the handle. Push the handle so it slides back
towards the main unit, then click back into
place. Please ensure the handle is secure before
picking up the unit.
NOTE
The handle on this appliance may seem
overly flexible, but it has been specially
designed to carry the entire weight of the
unit.