How To Switch Between The Raid Modes; Hard Drive Replacement And Data Rebuild Instructions - Raidon SafeTANK GT2670-WB3 Bedienungsanleitung

5.

How to Switch between the RAID Modes

! !
Storage Mode Definition
Independent mode ( JBOD ) : Two independent storage volumes without data protection.
Speed mode ( Raid 0 ) : One big independent data storage with accelerated data access but without data protection.
Safe mode ( Raid 1 ) : One independent data storage with data protection.
The default setting of GT2670 is JBOD. To change the setting, please shut off the power first. (When you switch between RAID
modes, all the data in hard drives would be erased. Please make sure that data has been backed up before switching between RAID
modes.)

6. Hard Drive Replacement and Data Rebuild Instructions

!
!
During the use of GT2670, if you are required to replace a malfunctioning drive, refer to chapter 4 "Hardware Installation". Once drive
replacement is completed and it is turned on, GT2670 will perform data rebuilding procedure automatically.
!
If, during the rebuilding process, a drive malfunctions and is unable to continue the rebuilding process, please restart GT2670 to
check and see that whether the drive is in fact malfunctioning. If it is, please refer to chapter 4 "Hardware Installation" to replace the
malfunctioning drive.
!
Note：
GT2670 allows suspension during data rebuilding process. If you turn off the power during the process, the system will automatically
continue to process the remains the next time you turn on the power of the unit. Please do not change the position and sequence of
the drives at any time.
SafeTANK GT2670-WB3 User Manual
! 5