Herunterladen Inhalt Inhalt Diese Seite drucken

Defrosting And Cleaning; Troubleshooting - SCAN High Cube Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Unplug your HighCube.
Clean and dry the inside of the appliance. Leave the door
slightly open to allow it to dry completely.
A cooler which is unused without being cleaned may start
to smell musty or develop mildew.

DEFROSTING AND CLEANING

Defrosting
The surface of the evaporator ices up when the refrigera-
tor is working. This is an entirely normal part of operation.
If the frost layer is more than 3mm thick, the cooler must
be defrosted and cleaned to avoid unnecessary energy
consumption and inefficient operation.
1. Remove all items inside and unplug the unit.
2. After defrosting, reset the temperature selector to original
position.
Cleaning
1. Unplug your HighCube.
2. Wash the interior with warm water and neutral detergent.
3. Dry all surfaces thoroughly.
Note: Do not use abrasive cleaners!
To ensure efficient operation the back and bottom of the
cooler should be cleaned thoroughly. Use mild soapy wa-
ter to clean the door seal.
Moving your HighCube
Unplug the appliance
Remove all items inside
Note: Never hold the appliance by the door.
Power Failure
If a power cut occurs, do not open the door more often
than necessary in order to conserve cold air.

TROUBLESHOOTING

Before returning your HighCube to the store, check the follow-
ing points; you may be able to solve any problem yourself.
Not Cooling
Check power cable is connected and fuse is intact.
Wrong temperature selected. Adjust setting on controller
to position shown (see page 10).
HighCube is overfilled.
Appliance exposed to direct sunlight or a heat source.
Door is opened too often.
Unusual noises or noisy operation
Appliance is not on a level, firm surface or may be tou-
ching other items.
Note: It is normal to hear refrigerant flowing as the com-
pressor stops and starts.
Outer surfaces are wet
Water source or leak too near the appliance – dry surfaces
thoroughly and move the appliance.
Inner surfaces are wet
Door opened too often or kept open too often.
Make sure that the door seals properly.
Warranty
This HighCube is guaranteed to be free from defects in parts
and manufacture for 12 months from date of purchase, provid-
ed that the unit is used under the normal operating conditions
shown within the manual. Your attention is drawn to the fol-
lowing:
The Manufacturer will not accept any liability for damage
or injury caused by improper use.
The manufacturer will not be liable for any damage caused
by moving the appliance; improper power supply; defec-
tive wiring or fuses; accident, alteration, abuse or misuse
of the appliance; abnormal operating conditions; commer-
cial or industrial use; fire; water damage; or customer mis-
use.
This warranty is void if service on the unit is performed by
any person other than an approved technician, or if the
appliance is used for commercial purposes.
This warranty is available only to the original purchaser and is
not transferable. Your normal consumer rights are not affected.
If service is required, DO NOT ATTEMPT TO REPAIR UNIT
YOURSELF. Please return unit to store.
Proof of purchase will be required for any warranty claims. You
must retain your original receipt.
If service under warranty is required, you will be required to
produce this. Please also retain the original packaging should
the unit need to be returned.
Please note: As part of our policy of continuous product im-
provement, the manufacturer reserves the right to amend
specifications without notice.
8

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für SCAN High Cube

Inhaltsverzeichnis