Tarmo 628752 Bedienungsanleitung

EN LED Motion Sensor Strip (AAA battery)
Features
- Human body sensor switch
- Battery for power supply
- Simple and easy to install
1. Specification
1. Install batteries, choose the MAN enter the manual mode, ON/OFF switch choice.
2. Manual mode switch to AUTO, the light on when entre to sensor area and keep 15 seconds.
3. If you stay sensor area all the time, the light keep 15 seconds after you leave.
2. Strips photoelectric parameters
LED strip size: 100 x 0,75 x 0,2 cm
Energy consumption: 2.4W
Voltage rating: DC 6V
Waterproof: IP65
3. Installation
Automatic / Manual switch
Clean the installation surface first.
Please cut the LED strip light through the lines marked on it accor-
ding to installation requirements.
4. Application area
Cabinet, chest, wall cabinet, bed light and so on.
628752_valonauha_liiketunnistimella_ko_EN-FI-SV-DK-NO-ET-LV-LT-DE-PL.indd 1 628752_valonauha_liiketunnistimella_ko_EN-FI-SV-DK-NO-ET-LV-LT-DE-PL.indd 1
Switch button
Human body sensor
4 x AAA
Connect the strip and sensor
with batteries as shown. Ext-
ra connector can be also used
if the connector wire is not long
enough.
LED strip
Velcro strip
Tear off the 3M adhesive tape
from Velcro and LED strip.
Install the LED strip and sen-
sor to the fixed position, the sen-
sor toward to the body induc-
tion area.
628752
ko1024
Info/Tootja/Ražotājs/Gamintojas:
Tammer Brands Oy, Viinikankatu 36,
33800 Tampere, Finland tammerbrands.fi
11.10.2024 9.19.14 11.10.2024 9.19.14