Flytec V002 Bedienungsanleitung Seite 4

EASY DISASSEMBLY
When assembling, the groove
column at the bottom
Figure 1). When disassembling,
remove the hull for charging
INSTALLATION OF REMOTE
Fill 2*" 1.5v" battery (purchased
direction as shown below.then
and lock the screw.battery
negative electrodes of batteries
reversed.
BATTERY CHARGING
As the boat hull shown (Figure 3), take out the battery
Remember to install the battery
After charging is completed,
BE CAREFUL
I.Make sure that the voltage
2.Before each charge, please
3.When charging, if the battery
will damage the battery.
please stop charging immediately.
4.1t is not advisable to leave for a long time while charging.
5.After many times of charging,
6.Do not put batteries in the fire or make
FREQUENCY MATCH
Put the boat on the water,
remote control power switch, the controller
the remote control bar, When the light stop flashing
successful, and the boat can be started
Note: I.After the waterproof
Installation is not in place
2.When the battery
find out the speed
3. When the battery
4. The water-inducing
remote control boat
Telecontrol operation
turn
turn
stop
turning
turn
The left and right operation
the model advances; the right control
control rod is pulled up alone, the left propeller
same time, and the two propellers
METHOD
position of the hull surface
of the crocodile head
take the stern paddle
and maintenance
CONTROL
separately) to the remote
cover the remote
note:when installing
must be recognized
to use after charging.
the indicator light is off (Figure 6).
and plug of the charging
discharge the remaining
is overheated, it means that it is overcharged,
If it is serious, it will cause
please increase
any modifications
make sure that the double
indicator
by pushing
cover is installed, it must be checked
or the waterproof
is near no power, the speed drops by 40%. At this time. the usage time is about 2 minutes. When
is reduced, please return
is running out. the frequency
paddle shaft must be in contact
instructions
turn forward
turn
backward
turn left turn
stop
right turn
turning
of the remote controller
rod is pulled up alone, the right propeller
work, and the model turns right.push
are reversed at the same time, and the boat
To know more products, welcome to visit out company website: http://www.iRctoy.com
should match
and installed tightly (see
shaft and take it out to
(Figure 2).
BATTERY
control in the right
control battery cover
batteries, the positive
accurately. it can't
and connect the charging
The USB indicator light is always
line meet your local standard.
battery.
permanent damage to the battery,
the charging time appropriately.
to avoid the risk of explosion.
paddle shaft completely
flashes for 1-2 seconds,
and keep long-light state, that the automatic
the remote control bar.
that the installation
cover is not installed. The function
the boat in time.
may not be matched.
with the water surface to match the frequency
Technical
v005
is pulled up at the same time, two propellers
— 02 —
the
Figure 1
plate
and
be
cable (Figure 4) during charging.
red when charging
Figure 3
which
Figure 5
touches the water surface,
the frequency matching
frequency
is in place before
will not be normal.
Please remove the battery
Parameter
32cm
3
31cm
work at the same time,
works, the model turns left; the left
the control bar to backward
move backward.
Figure 2
Remote control
2x"1.5V" Battery
( Figure 5).
Figure 4
Figure 6
then turn on the
process can not push
matching is
using it. If the
in time and charge
and start the
17cm
14.5cm
at the