Using The Appliance - Clatronic LE 3612 Bedienungsanleitung, Garantie

NOTE:
• The display shows the current air humidity level with a value
between 35% and 95%. The POWER
indicates that the unit is ready for use.
• If the SPEED or indicator lamp lights up, the previous
operation had been stopped due to power failure. The unit
will start immediately with the previously selected settings
(except for timer function).

Using the Appliance

Turning unit on/off
• Press the POWER button to turn on the unit.
• Press the POWER button again to turn off the unit.
Setting the humidity level
Press the SETTING button to select the desired air humidity level.
Select a setting between 40% and 80% in increments of 5%.
Fan settings
Press the SPEED button to switch between slow and fast power
setting of the fan.
Timer (Automatic timer)
Use the timer function to set the power-on and power-off times of
the unit. Select a time between 1 and 24 hours.
Using the timer function for automatic power-on
1. Press the POWER button to turn on the unit.
2. Select the desired air humidity level. Then select the fan power
setting to be used when the unit starts operation when pow-
ered on.
3. Press the POWER button to turn off the unit.
4. Press the TIMER button repeatedly to set the hour as desired.
When performing the setting, the hours flash in the display.
When the time has elapsed, the unit will turn on automatically.
Using the timer function for automatic power-off
1. Press the POWER button to turn on the unit.
2. Press the TIMER button repeatedly during operation to set the
hours as desired. The hours after which the unit will power off
automatically, will briefly flash.
WARNING:
• Always disconnect the mains plug from the wall socket before cleaning!
• Make sure no water enters the openings of the unit during cleaning.
• Never immerse the appliance in water! Otherwise this might result in an electric shock or fire.
CAUTION:
• Do not spray the device with cleaning agents.
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
NOTE:
• In order to deactivate the timer function, use the TIMER
button and select "00".
indicator lamp
• You may also cancel the timer function at any time by press-
ing the POWER button to turn the unit on/off.
Emptying the water tank (see figure C on page 4)
The water collection tank (7) collects the water from the air humid-
ity. When this tank is full, the unit will emit several beeps. The unit
will automatically switch into STANDBY mode. The
lamp lights up.
You must empty the water tank in order to continue operation.
CAUTION:
1. Always disconnect the mains plug first. Otherwise the unit will
immediately activate the compressor once you have installed
the emptied water tank. That could cause damage to the
compressor.
2. Pull out the water tank at the recessed handle.
3. Pour out the collected water.
4. Use both hands to push the water tank back into the unit.
5. Wait for approx. 10 minutes and then start operating the unit
again.
NOTE:
• The floater must not be removed. It is required for detecting
the water level.
• If the water tank is not properly installed inside the unit, the
"water tank full" sensor will be activated and operation cannot
be continued.
Terminating operation
1. Press the POWER button to turn off the unit. The SPEED
indicator lamp and possibly the TIMER indicator lamp will also
turn off.
2. Disconnect the mains plug from the wall socket. The POWER
indicator lamp turns off.
Cleaning
Water collection tank
• Clean the tank with lukewarm water and a cloth.
• Dry the tank before pushing it back into the unit.
indicator
31