Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
• After successful registration, the DECT Repeater can be separated from the power supply.
Then put it in operation, where you want to improve the reception of DECT handsets.
• Find a place on the edge of the reception range of the base station to extend the range pos-
sibly well. To do this, set up a connection to the base station with the handset and stray so
far from it that a better reception is possible. This is the best mounting place for the DECT
Repeater.
• The DECT Repeater can be suspended to the wall by means of a screw (there is a mounting
hole on the back of the DECT Repeater).
Pay attention when drilling/tightening the screws that no power, gas or water pipes
are damaged!
Find a place that is not near electrical wires or devices.
Keep sufficient distance to metal parts (e.g., radiators, metal doors).
Mount some DECT Repeaters side by side. Keep a minimum distance of 10 metres
between the DECT repeaters and also to the base station (in case of overlapping
reception range).
For best reception, the DECT Repeater should be mounted as high as possible.
After mounting and connecting to the power supply, the green LED indicator on the
DECT Repeater must flash permanently. If it is flashing red, the reception area is
exceeded and the DECT Repeater must be mounted closer to the base station.
Maintenance and Care
Before cleaning the DECT Repeater, disconnect it from the power supply (unplug
the power supply unit from the mains socket!).
Absolutely prevent wetness or dampness from penetrating into the device.
• Never use abrasive cleaning agents, rubbing alcohol or other chemical solutions, since these
could damage the housing or even impair operation.
• Use a dry, lint-free cloth to clean the product.
Declaration of Conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this
product conforms to the 2014/53/EU directive.
The full text of the EU conformity declaration is available via the following Internet
address: www.conrad.com/downloads
Select language by clicking a flag symbol and enter the order number of the product
in the search field; then you will be able to download the EU declaration of conform-
ity in PDF format.
Disposal
Electronic devices are recyclable material and do not belong in the household
waste. Dispose of an unserviceable product in accordance with the relevant statu-
tory regulations.
Technical Data
Operating voltage of power adapter ......... 100-240 VAC, 50/60 Hz
Operating voltage of DECT Repeater ....... 5.5 V/DC
Range ....................................................... 50/300 m (Indoor area/free-field conditions)
Transmission standard ............................. DECT GAP
Sensitivity ................................................. -92 dBm
Operating conditions ................................. -10 to +50 °C
Dimensions (W x H x D) ........................... 120 x 130 x 30 mm
Weight ...................................................... 130 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
1499656_V1_0916_01_VTP_m_en
Werbung
Inhaltsverzeichnis
