Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
Wireless sockets set
Scope of supply
• 3 wireless sockets
• 1 remote control
• 1 battery type CR2032
• Instruction
Specifications
Operating frequency:
Operating range:
Building code:
Device code:
Voltage:
Power:
Battery:
Preparation for use
• Remove the battery cover and insert the battery (CR2032).
• Insert the switch you wish to connect to your remote control into the power
point.
• The LED on the switch will flash for 10 seconds. During this time, you can
connect the switch to your remote control. If you wait longer, the LED will turn
off. If this happens, remove your switch from the power point for a few seconds
to reset it.
Connecting your remote control to a switch
You can connect up to five remote controls to your switch.
• Press one of the left ON buttons on the remote control to connect the switch to
one of the 3 channels of the remote control (A/B/C). The LED on the switch will
now stay lit. The switch is now connected to the remote control.
• Connect your other switches to a channel in the same way.
Operating a switch
• Press one of the left ON buttons (A/B/C) on the remote control to turn on the
switch(es) connected to this channel.
• Press the corresponding right OFF button on the remote control to turn off the
switch(es). The LED on the switch will not light up now.
• The master key can control all switches at the same time on or off. Insert the
plug of the device into the socket of the switch.
5
433.92MHz
max. 30m (environment dependent)
Self-teach function
3 channels + Master
230V ~ 50Hz
1000W
1x 3V DC Lithium battery (CR2032)
GB
Werbung
