momit HOME EXTENSION KIT Bedienungsanleitung Seite 2

INSTALLATION AND
You must have at least
a momit Home Thermostat
installed
2. CUT OFF THE ELECTRICITY
THE INSTALLATION AREA
Remove the 2 screws
3.
4. Enter your finger on the back and open
the case with hinge movement
5. Use the screws provided
back case to the wal
6. Connect the 2 boiler
110-220 VAC power wires
7. Close the case.
8. Screw the 2 screws
9. Turn on the power in the installation
area.
10. The LEDs should flicker
indicate that the device is working
properly. Then check that the power icon
It's on and not flickering
11 Scan the QR code on
register it on the momit app and link it to
the momit Home Thermostat
•Gateway: Device that works as a router making
it possible to connect the thermostat
Internet.
REGISTRATION
a *Gateway and
connected
FROM
from the bottom
to secure the
wires and the 2
into the bottom
3 times to
the device to
you want
to the
ITALIANO
3.
0
s.
9. 10.
7. 8.
11.