Ikra LS 3011 Gebrauchsanweisung Seite 23

Troubleshooting
Attention! Always remove the plug from the mains socket before starting any work on the machine.
Problem
Device does not start
Device works with interruptions
Low suction capacity or suction
not present
Small or missing blowing power
Device works with interruptions
Possible cause
Mains voltage is not present
Defective on/off switch
Worn carbon brushes
Defective motor
The suction tube is not fully inserted
onto the main housing
Damaged power cable
Internal loose connection
Defective on/off switch
Collection bag is full
Collection bag is dirty
Selector switch in incorrect operation
mode
Device clogged up or blocked by
foreign bodies
Selector switch in incorrect operation
mode
Speed control in incorrect position
Foreign body blocks impeller wheel
GB-8
Fault correction
Check plug socket, cable, line, plug and
fuse, where appropriate, repair through
electrical specialist
Repair through customer service
Install a two-part blowing/suction tube
Check cable; where appropriate, replace
Repair through customer service
Empty grass collection bag
Clean grass collection bag
Set selector switch to the suction mode
Remove plug or blockages (see chapter
Cleaning and Store)
Set selector switch to the blowing mode
Rotate speed control to high position
Remove blockage (see chapter Cleaning
and Store)