V-TAC VT-13 Bedienungsanleitung

V-TAC@
INNOVATIVE L EDLIGHTING
INSTALLATION
INFRARED LED SENSOR LAMP
MODEL
WARRANTY*
INTRODUCTION
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best.
Pleasereadtheseinstructions carefully before starting the installing and keepthis
manual handyfor future reference.If you have any anotherquery, pleasecontact
our dealeror local vendor from whom you have purchasedthe product. They are
trained and readyto serve you at the best.The warranty is valid for 3 yearsfrom the
date of purchase.The warranty doesnot apply to damagecausedby incorrect
installation or abnormal wear and tear.The company gives no warranty against
damageto any surfacedueto incorrect removal and installation Ofthe product. The
productsaresuitable for 10-12Hours Daily operation. Usageof product for 24 Hours
a day would void the warranty. This product is warrantedfor manufacturing defects
only.
WEEE Number. 80133970
INSTRUCTION
- VT-13
provided by
snMSUNG
& WARRANTY
V-TAC@
INNOVATIVE L ED LIGHTING
SPECIFICATIONS
Voltage/Freq: AC:220-240V50/60Hz
Ambient Light:<3- 2000LUX(adjustable)
Time Delay:Min. 10sec ± 3sec
Max.3min± 30sec
Watts/Lumens: 12W/800 Lumens
Detection Range: 3600
FUNCTIONS
• Canidentify dayandnight:Theconsumercanadjustworkingstate in different ambientlight.
• It canwork in the daytimeandat night when it is adjustedonthe "sun" position(max).It can
work in the ambient light lessthan 3LUXwhen it is adjusted on the "moon" position (min)
As for the adjustment pattern, please refer to the testing pattern
• Time-Delay is added continually: When it receives the second induction signals within the first
induction, it will restart to time from the moment
• Adjustable Time Delay:the length of time delay could be set according to the customers
requirement, the minimum time is 10sec±3sec, and the maximum is 3min±30sec
Good sensitivity
INSTALLATION
• Switch off the power.
• Unscrew the plastic screw nut and remove the PClampshade. (refer to figure I)
• Pass the wire through the hole in the bottom and connect the power wire into
connection-wirecolumnaccordingto the connection-wirediagram.Installthe sensorlamp
in the position where you need with inflated screws. (refer to figure2)
• Switch on the power and test it.
Detection Distance: max.6m 1<24C)
Working Temperature: -20N+40•C
WorkingHumidity:
Installation Height: 2.2-4m
Detection Moving Speed: O .6-1.5m/s
Poor sensitivity