SPEEDLINK ACUTE PRO Bedienungsanleitung Seite 4

EN
1. Open the battery compartment on the back of the Wireless
Presenter and remove the USB receiver. Insert an AAA battery
(1.5V) making sure the polarity is correct. Close the battery
compartment again.
2. Plug the USB receiver into any free USB port on your computer.
The operating system will automatically detect and install the
device.
3. Switch the device on by setting the switch on the back to ON.
If you do not intend to use the Wireless Presenter, simply set the
switch to OFF to save power.
4. The connection will be established automatically in a few
seconds. If this doesn't happen, press the Connect button on the
back of the Wireless Presenter.
5. Use the switch on the right-hand side to switch between
Presenter (up) and Mouse (down) Mode.
6. Refer to the graphic for the button functions. Be aware that the
button configuration depends on the mode selected. For safety
reasons, the laser pointer only works in Presenter Mode; mouse
functions are only available in Mouse Mode.
7. The device will switch to power-saving mode automatically after
around 6 minutes. Press any button to awaken the device from
this mode.
8. For easy transportation, the USB receiver can be stowed in the
battery compartment.