PCL D3 Serie Kurzanleitung

PART NUMBER
SERIAL NUMBER
FREESTANDING AIR & WATER TOWERS & PODIUMS
Quick Start Manual
Please read these instructions carefully before attempting to assemble, install, operate or maintain the product. Protect yourself and
others by observing all safety information. Failure to do so could result in personal injury and/or damage to property. Retain these
instructions for future reference.
For D3x, D7x, D8x & D9x models
Safety Guidelines
Please read and follow the accompanying
Safety Instructions before continuing.
Please ensure all operators are familiar
with the Safety Instructions.
The equipment must be used in the manner specified by the
manufacturer otherwise the safety protection provided by the
equipment may be reduced.
General Specifications
Max operating pressure:
Min operating pressure:
Display resolution:
Max permissible error (MPE):
Voltage and power:
Operating temperature range:
Internal compressor pressure:
Maximum Sound Pressure Level:
Suitable for outdoor installation
Installation
Please ensure all safety information is visible to the
operator.
The product should be mounted securely to a solid floor using
anchor bolts in all mounting holes provided. Electrical, air and/or
water services are intended to enter through the access hole(s) in
the base of the unit.
Mounting diagrams are provided overleaf for all models.
The
equipment. Where manual handling is
required use two people.
Note that the unit is screwed down to the pallet. Remove all
screws holding the unit (and coin vault) to the pallet.
Air supply
For models without an internal compressor the air supply should
be clean and dry. This will minimise the accumulation of dirt and
water in the inflator filters.
The air supply should be connected to the R 1/4 port on the
inflator filter.
For efficient tyre inflation, ensure that the air supply is at least 10
psi / 0.7 bar above the intended maximum target pressure.
76519 Issue 5
between 5.5 and 10 bar
(see product rating label)
0.3 bar
0.1 bar
0.08 bar
see product rating label
-10 °C to +55 °C
7 or 10 bar
80DBa
product is heavy, use
www.pclairtechnology.com
Water supply
For models with water connect the water
supply to the units 15mm
fitting.
Ensure the shut off valve is opened before
use (as shown)
lifting
Actual product may vary by model.
push-fit pipe