Unique XD-032 Betriebsanleitung

XD-032/XD-034
EN INSTRUCTION MANUAL FOR ELECTRONIC SAFE
Main keyhole Digital display
Password panel
Unified factory password for personal code: 1234, administrative password: 123456
1. Press the # button once, enter a valid personal code or management code. Then "Open" will appear on
the screen. Open the door within 7 seconds.
2. If the password is not correct, "Error" will be displayed and the input status will be returned. Entering
an incorrect password three times will cause an alarm lasting 1 minute. Entering the correct password can
clear the alarm, otherwise otherwise the alarm will automatically turn off after one minute.
3. Keyboard action: * Clear the entered digit. Press the * button to clear the wrong digit each time.
4. to hide the entered characters when opening the door, press the # button once, and then press the *
button again. The entered password will be displayed as "0".
To make the display show numbers enter: # > 1234 > Press # > open the door
Touch the screen: Wake up > # > 1234 > press # shows open > open door
Emergency keyhole
Emergency power hole
Setting and changing the personal code and administrator code
First press # to launch the screen, then enter the personal code. Press # to confirm. Press * within 7
minutes when "Open" ( Open) appears on the screen.
You can set the personal code when ">" appears on the screen, and then enter the new password.
Press the confirmation button. When "into" appears on the screen, it means successful setting.
Note: You cannot set a new code if the original code is not correct.
Example. Setting and changing the personal code
Personal code: # > 1234 > press # open > * > 888 > # > completed successfully.
Admin code: # > 123456 > press # open > * > 8888 > # > completed successfully
Personal and touch screen management code set
Personal code: Touch the touch screen to launch the computer card > # > 1234 > press # open > * > 888 >
# > completed successfully
Setting and releasing the vibration alarm
When the unit is in the sleep state, press "0", the display will show "bell on" and maintain the alarm state.
The alarm will turn off when the correct code is entered.
Date and time settings
The date can be set when the safe is asleep, press *.
Adjusting the regular LCD display
When the date is displayed, press # to switch the date (year/month/day), and "0" means decrease by one
digit, "8" means increase by one digit.
Touch screen adjustment
touch the screen to launch the computer tab, press * to switch the date (year/month/day).
Enter the appropriate number to adjust the date, it will change to sleep mode.
Other
The main board consists of a 4-1.5 volt alkaline battery. When "lobatte" appears on the screen, it means
too low voltage, warning that the battery needs to be replaced. When the battery level is low, you can use
an external power source. Operating voltage: 4.6V-6.0V.
If the code is forgotten or lost, press the red or green button inside the door to restore the unit's default
password, personal code 1234, administrator password: 123456.
WARNING: DO NOT PLACE THE MANUAL AND EMERGENCY LOCK IN THE SAFE