Polytron MPX 106 D Bedienungsanleitung Seite 96

After clicking the button "Batch Setting" multiple channels can be configured at the same time. After that, the
following menu will be opened to configure the key data.
After pressing the button "Apply" all adjustments will be accepted.
Note
It is important to avoid IP conflicts between base board, the modules and other devices.
The activation of "Destination MAC" is only necessary in certain cases where a unicast stream cannot be re-
ceived for unknown reasons. To remedy this, the MAC address of the receiver can be activated and the correct
recipient MAC address can be entered. This will be used instead of the unicast IP address.
The "Service Configuration" menu is used to be set the service data (TS data, NIT) for the assigned programms.
If necessary, the service PIDs can be set here.
After clicking on the desired transport stream, the menu for setting the following data will be opened:
 Original Network ID
 TS ID
 Service ID
 Service Name
 Service Provider
After selecting the menu to adaption the NIT will be opened.
96
(automatic transfer from the first service by selecting MUX)
(automatic transfer from the first service by selecting MUX)
(automatic transfer from the transport stream)
(automatic transfer from the transport stream)
(automatic transfer from the transport stream)