LLG -Timer pro Benutzerhandbuch

User Manual LLG-Timer pro
®
Art.No.: 6.311 351
L A B W A R E
Button
MODE To switch between CLOCK and TIMER
CLEAR To clear the timer or bring up the memory time
H To adjust „hour" value
M To adjust „minute" value
S To adjust „second" value
START/STOP
To start or pause the timer
Set the clock time
1. Press the MODE button to switch to enter CLOCK MODE.
2. Press and hold the MODE button to enter setting mode.
3. Press the H button to increase „hour" value, press and
hold to increase quickly.
4. Press the M button to increase „minute" value,
press and hold to increase quickly.
5. Press the S button to set „second" value on zero.
6. Press the MODE button to finish the setting.
Display 12 or 24-hour system:
* in the CLOCK MODE, press any of the 3 buttons H,
M or S to change the hour system.
Set the countdown time
1. Press the MODE button to switch to enter TIMER MODE.
2. Press the H button to increase „hour" value, press and
hold to increase quickly.
3. Press the M button to increase „minute" value, press and
hold to increase quickly.
4. Press the S button to increase „second" value, press and
hold to increase quickly.
• You can set up to 99 hours 59 minutes 59 seconds of the
countdown time.
• Press the CLEAR button to clear the timer. Press once
again to bring up the memory time.
LED LIGHT LED LIGHT
Sound
Mute
Off
Start the countdown
• After setting the countdown time,
press the START/STOP button to start the countdown;
press the START/STOP button again to pause count-
down; press the START/STOP button again to continue
the countdown.
The setting will be saved in the memory.
After the end of countdown
• When the timer has counted down to zero, the timer will
then start counting up from zero, the led light will flash
for 1 minute and the alarm will sound for 1 minute.
• Press the START/STOP button to return immediately to
the set countdown time.
se the count up Stop watch- >>
U
• Press the MODE button to switch to the TIMER MODE.
1. Press the CLEAR buttons to clear the timer when the
timer is paused
2. Press the START/STOP button to start count up.
• The timer can count up to 99 hours 59 minutes
59 seconds.
How to place the product - >>
• You can use the hanging bracket to hang it on the wall or
other places.
• The product can stand upright on the table with the
bottom bracket unfolded.
• This product comes with a magnet, it can be attached
onto the metal surface of the iron box or refrigerator.
How to replace the battery - >>
When the power is low, the display becomes dim or unclear.
Replace the battery when the battery power is low.
1. Hold and push the battery cover towards the direction
indicated by the down arrow
the battery cover.
2. Remove the old battery, and put on a new battery
according to the correct polarity direction.
3 Replace the battery cover.
Which battery is needed- >>
2 x AAA
q
to open
V.2