ProLinx 246MIR-10C Gebrauchsanweisung

260*190MM
USB RECHARGEABLE WIRELESS REMOTE CONTROL AND MOTION
ACTIVATED COLOR CHANGING LED SPOT/CEILING LIGHT
24 key Remote Control (see the function
of each button at the bottom)
*Lights will default to last brightness & color setting when you turn lights off & on again via remote. If
you want to adjust the brightness level of lights again, please press (
you press the motion ON button now, the light will keep last brightness & color setting as is. Light will
auto off in 45 seconds if no motion detected. Lights will auto ON to last brightness & color setting when
motion is detected again. If you want the lights will auto ON in defaulted white color when motion
detected, you can press the motion OFF & motion ON button again.
Operations:
Decreases the brightness
for RGBW & slow down for
Flash/Strobe/Fade/Smooth
(Level 1 to 5)
Increases the brightness for
RGBW & speed up for
Flash/Strobe/Fade/Smooth
(Level 1 to 5)
Timer Setting:1/2/3/4 Hours
)/( ) buttons on remote. If
Direct the Remote Control towards Remote
Control Signal Receiver on lights up to 20 feet
Remote
Off On
Multicolor
7 color flashing in cycle: Approx. 10 seconds
(level 1), 15 seconds (level 2), 20 seconds (level 3),
25 seconds (level 4), 30 seconds (level 5)
Red
7 color changing in cycle from bright to dim: Approx.
FLASH
Green
8 seconds (level 1), 12 seconds (level 2),
16 seconds (level 3), 20 seconds (level 4),
Blue
STROBE 24 seconds (level 5)
White
7 color changing gradually: Approx. 10 seconds
FADE
(level 1), 15 seconds (level 2), 20 seconds (level 3),
25 seconds (level 4), 30 seconds (level 5)
SMOOTH
7 color flashing in cycle plus RGB color changing
gradually: Approx. 15-55 seconds (level 1-5)
Motion Sensor