Maclean Energy MCE151 Kurzanleitung

Diese Anleitung herunterladen

Remote Controlled Switch Socket

FUNCTION:

• Random/Learning code.

•

Operation code is 24 bit address code and CRC check,

repeat probability is 1/16,777,216.

•

Every transmitter can control up to 4 channels (1ON, 1OFF, 2ON, 2OFF...etc).

each channel can control one certain receiver

•

Receiver has a built-in memory, it can remember the data for 10 years.

•

Battery life is 2 years.

OPERATION:

1. Open battery cover of Transmitter and put 2 AAA 1.5V battery in it. Then press any

ON/OFF channel to check whether it can work. If LED indicator of transmitter turns on,

it means this Transmitter works well.

2. Put Receiver into outlet, LED indicator shows slow flashing. Enter into channel selection

mode. Note: Receiver will exit channel selection mode after 29 sec. without any operation.

3. Press Transmitter's A ON, B ON, C ON or D ON to match with Receiver. Once successfully,

LED indicator stops slow flashing, then you can turn this Receiver ON/OFF by pressing

selected ON/OFF channel.

4. Clean selected channel: Pull out Receiver and put in (LED indicator shows slow flashing

as channel selection mode), then press and hold OFF key of selected channel until LED

indicator shows fast flashing (3-4 seconds), which means selected ON/OFF channel is

cleaned. After that, Receiver returns to channel selection mode. Total time is 29 seconds.

MCE151

MCE153

-1-

Seite 1 MCE151 MCE153 Remote Controlled Switch Socket FUNCTION: • Random/Learning code. • Operation code is 24 bit address code and CRC check, repeat probability is 1/16,777,216. • Every transmitter can control up to 4 channels (1ON, 1OFF, 2ON, 2OFF…etc). each channel can control one certain receiver •...
Seite 2 5. Clean all selected channels: Pull out Receiver and put in (LED indicator shows slow i przytrzymaj guzik OFF 'ALL ON/OFF' dopóki wskaźnik led nie zacznie szybko migać flashing as channel selection mode), then press and hold OFF key of ALL ON/OFF channel (około 3-4 sekund), co będzie oznaczać...
Seite 3 du canal sélectionné jusqu'a ce que le LED clignote rapidement (3-4 secondes) ce qui diesem Verfahren schaltet der Empfänger wieder in den Kanal-Auswahl Modus und Sie signifie que le canal sélectionné ON/OFF est nettoyé.Apres cela, le récepteur retourne au haben eine Auswahlzeit von 29 Sekunden. mode de sélection de canal.
Seite 4 4. Limpie el canal seleccionado: quite el receptor y que se presenten 3. Premere di trasmettitore A ON, B ON, C ON o D ON da abbinare con la ricevente. (LED parpadea lentamente en la selección del canal de la moda), a continuación, Una volta con successo, indicatore LED smette di lampeggio lento, quindi è...

Mce153