After the previous step, now rotate it vertically in the same direction until a "beep beep"
sound is emitted and the rear LED lights start flashing slowly in red.
The geomagnetic calibration process is now complete.
After completing the magnetic calibration process, place
the drone on a flat surface or terrain, and it will begin
connecting to GPS satellites.
In the upper right corner of the controller screen, the
number of connected satellites is displayed.
For proper operation, the drone should be connected to
at least 13 satellites.
Note: The drone is set to GPS mode by default. If you
want to fly indoors, press and hold the GPS button.
STARTING THE FLIGHT
Ensure that the drone is at a safe distance before takeoff.
There are two ways to start the flight:
-Move both the left and right control sticks
simultaneously as shown in the image, and the motors
will start spinning. The drone will then be ready for
takeoff.
-Press the takeoff button as shown in the image, and the
drone will automatically rise 1.5m off the ground and
hover, ready to be piloted. Press it again to land
autonomously.
16