Dimplex CFCH Bedienungsanleitung Seite 4

Program mode (PROG) - see Fig. 8
1. Navigate the cursor to PROG with the
enter . Choosea programnumberbetween1 and32 with the +
buttons and press enter
2. Set the days with + — choosing either Single days, Monday until
Friday, Saturday and Sunday or Monday until Sunday. Press the enter
button4.1
to accept.
3. Set the program start time with + — and confirm the hours and
minutes with the enter button
4. Set the program stop time with
minutes with the enter button
Note: Always set start time before setting the stop time.
5. Set the desired ambient room temperature (thermostat setting) with
+ — and confirm with the enter button
6. Set the heat settingbetween*
HEAT and HIGH HEAT with the + — buttons and confirm with the
enter button
7. Ail settings for the first program are now done. Enter a new program
according to the steps 1-6 or activate the aiready entered program by
leaving this menu with the
8. In order to continuously run the entered program the cursor must be
positioned under the PROG symbol. The heater wilt operate according
to the entered information-
number willappearwiththe pre-setandambient t emperatures O
afternating.
9. An entered program can be checked, edited or deleted just by navigating
into the PROG menu and pressing the enter button. With the +
buttons the different program
program number is selected (flashing) the start/stop time will alternate
according to any pre-entered
number, press the button. The CP symbol (clear program) appears
and by pressing the enter button
leaves the menu without deleting the program.
Time setting (TIME) - see Fig. 9.
Navigate the cursor to TIME with the
button to adjust the weekday with the
enter button and set the hours
button or to leave the time
Frost protection - see Fig. 4.
Choose a heat setting and set the desired ambient temperature between
50C and 80C (see 'Operation').
When the temperature falls below +5 oc...+8 oc. the heater switches on
automatically.
buttons and press
— and confirm the hours and
(fanonly)/ LOWHEAT/MEDIUM
button
When a program is running, the program
numbers can be selected.
information, To delete one program
this p(ogram will be deleted.
buttons. Press the enter
— buttons. Confirm with the
and minutes with — . Press
menu.
-2-
Cleaning
WARNING : ALWAYS DISCONNECT
BEFORE CLEANING
Donotusedetergents, abrasive cleaning powders or polishof anykind
on the Controller.
Wipe with a dry cloth to removedust anda damp cloth (notwet) to clean
off stains. Be careful not to allow moisture into the Controller.
Use a vacuum cleanerto removeany fluff which accumulateson top of
the Controller.
Care must be taken to avoid any moisture ingress into the product.
After Sales
Should you requireafter sales serviceor should you need to purchase
any spares, please contact the retailer from whom the heater was
purchased or contact the service number relevant to your country on
the warranty card.
Please do not return a faulty product to us in the first instanceas this
mayresultin lossor damageanddelay in providingyouwitha satisfactory
service.
Please retain your receipt as proof of purchase.
When a
the enter
FROM THE POWER SUPPLY
THE HEATER
Service