Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EATB
190*76*15
12-60
9
Model
Plate
Exchanger
Installing
Support
1.This product should be used for welding spigots when using refrigerant
to avoid refrigerant leakage.
2.If undissolved solids like sand, weeds, leaves, and other fibers are in
the water, the channels are easily blocked; we recommended using a
40~70 mesh strainer to avoid blocking.
3.Any heat exchanger could freeze up when the temperature is below
zero. Freezing upinside the heat exchanger will result in structural
damage and leaking. If leaking happens in the evaporator, even the
compressor could be destroyed. In order to avoid freezing:
* Use a freeze protection thermostat and flow switch to guarantee a
consistent water flow before, during and after compressor operation
*Avoid operation the unit during pump downtimes, Discharge the water
when the exchanger is left unused and keep heating the water when in
use.
*Use antifreeze when the evaporating temperature is close to liquid side
freezing, Adding glycol or other antifreezing in the water .
4. Cleaning: Regular reverse flushing insitu is the sumplest option. If
however, scaling has occurred, chemical cleaning will be necessary,
Clean with detergents for fatty deposits (without chlorine), for heavier
3.0
Part List
Picture
EATB28-30/50/80/100
Security & Warnings
60
4*1/2"G
1
2
- 3 -
0.48L/0.4
3.3
48L
EATB12-30/40/60
1
2
Werbung
