Meowant MW-WP04 Bedienungsanleitung Seite 2

1. Product Introduction
Thank you for choosing our pet water dispenser pump. This pump is specifically designed for pet
water dispensers, aiming to provide a stable and clean water source, ensuring your pets have
access to fresh water at all times.
2. Product Specifications
Model: MW-WP04
Input Voltage: DC 5V
Power: 2W
Pump Flow Rate: Approximately 200L/h
Noise Level: < 40dB
Material: Food-grade plastic, meets UL standards
Dimensions: Length x Width x Height (cm)
3. Installation Guide
Unpack and Check: Open the package and check that all accessories are included, such as the
pump, power adapter, water inlet hose, outlet hose, and instruction manual.
Install the Pump:
Place the pump in the designated space of the water dispenser base, ensuring a good connection
with the water source.
Connect Power: Plug the power adapter into the pump, ensuring that the plug is securely
inserted into an outlet.
Check for Leaks: Before powering on, check that all connections are secure to prevent leaks.
4. Operating Instructions
Power On: After connecting the power, the pump will automatically start, beginning to circulate
the water.
Water Level Detection: The bottom of the water dispenser is equipped with a water level sensor.
The pump will automatically stop when the water level is too low to prevent dry running.
Power Off: If not in use for an extended period, please disconnect the power.
5. Maintenance and Care
Regular Cleaning: Clean the pump and water dispenser weekly to avoid buildup of scale and
bacteria.
Replace Filter: If the water dispenser is equipped with a filter, please replace it regularly; the
specific replacement cycle depends on the frequency of use.
Check Power Cord: Regularly check the power cord and plug for damage to avoid safety hazards.
6. Frequently Asked Questions
Pump Does Not Start: Check if the power connection is normal and whether the water level is
below the sensor.
2