Operating; Maintenance, Cleaning & Storage - Eleeels R3 Bedienungsanleitung

INSTRUCTIONS
PLEASE READ PRIOR TO USE
CHARGING
1) Connect USB Type-C cable to the charging port.
2) The charging speed depends on what adapter is used. It is suggested to use
an adapter supporting Type C (5V/2A) to fully charge in approximately 3
hours.
3) When the power indicator flashes, please recharge the battery.

OPERATING

• First, use the strap to hold the device on the knee joint, and adjust the
tightness.
• Then, press the power button for 2 seconds to turn on the device. The default
setting is Auto Mode (auto vibration, low heat level, infrared, laser).
• Press the vibration button repeatedly to adjust the vibration level during
operation.
• Press the heat button repeatedly to adjust the heat level during operation.
• Press the power button repeatedly to turn on and turn off infrared and laser
during operation.
• Press the power button for 2 seconds to turn off the device.
• When the device stops operation after a 10-minute session, press the power
button to start a new one.
MAINTENANCE, CLEANING & STORAGE
• Use a slightly damp towel to clean the device and a soft cloth to dry it.
• Do not clean the device with chemicals or alcohol.
• Only use the USB Type-C cable supplied by the ELEEELS for recharging.
WARNINGS & CAUTION
• Do not immerse in water. Keep away from liquids or heat sources. Keep
ventilation ports free from dust and debris.
• Do not remove screws or attempt to disassemble.
• Do not operate continuously for more than one hour. Allow device to rest for
10 minutes before re-using.
• For adult use only. Do not use if injured. Consult your doctor before using this
product.