Adjustable Head - Evolution R2700 Wlt Li Originalbetriebsanleitung

www.evolutionpowertools.com
OPERATING INSTRUCTIONS
To install/remove the battery
To install the battery insert firmly into the tool until you
hear an audible click, ensuring the battery is fully seated
b
and latched into position.
To remove the battery depress the battery release
a
button and pull the battery out of the tool.
DC socket
Power can be supplied by an AC adaptor or battery pack.
While the DC socket supplies power, the battery pack will
FIG.1
stop working. Before using the DC socket, pull out the
rubber cap.
WARNING: When the DC socket is not in use, the rubber
cap should remain on the socket to prevent the build up
of dust.
On/off (Fig.1)
To turn on the light press the on/off switch (a).
To turn off the light press the on/off switch again.
To choose a power level, press the light power level
switch (b) to choose from three brightness levels.
EN
WARNING: Do not direct the light beam into eyes.
Hanging the work light
The work light can be securely hung from the hanging
hook as required. Ensure the light is secure and cannot
fall.

Adjustable head

The Work light head can be set in a variety of positions.
To switch base positions, turn the adjusting knobs to
loosen. Adjust head to desired position, tighten the
adjusting knobs.
CAUTION: Do not place hands or fingers between
adjustable head and bracket when positioning work light.
7