Pro-Ject Audio Systems Stereo Box S3 BT Bedienungsanleitung Seite 9

Amplifier capacity - power handling
Your loudspeaker system will operate satisfactorily with any good amplifier designed for use with an 4-8 Ohm
impedance load. Although loudspeakers are designed to handle high power loadings, you must remember
that any loudspeaker that is abused with excessive use of volume, tone controls and graphic equalizers is likely
to cause damage to the drive-units. Be careful especially with small amplifiers constantly driven on high power
levels as these may be liable to go into „clipping mode" and distort the signal causing possible damage. If you
hear a distorted signal through the loudspeakers, you must reduce the power level.
Connection to your amplifier
We strongly recommend the use of high-quality speaker cables, colour coded or grooved cables are
recommended to assist checking polarity, your local dealer should be able to advise you on this point. Always
switch OFF your amplifier before making any connections or adjustments to the system. Wire the right-hand
channel cable so that the positive (RED) terminal of your loudspeaker is connected to the positive (RED) on
your amplifier, and the negative (BLACK) terminal of your loudspeaker is connected to the negative (BLACK)
terminal on your amplifier. Repeat the instructions for the left-hand channel. Do NOT connect more than one
loudspeaker to one terminal on your amplifier.
Set the volume level to minimum before switching on the amplifier!
Speaker Grills
We recommend operating the speakers without grills, as the delicate treble can spread absolutely freely. Our
almost acoustically transparent speaker grilles only serve as protection against outer influences (e.g. pets).
Wall mount
Wall mount brackets are available separately. Please contact your dealer for further information.
3
© Pro-Ject Audio Systems · Speaker Box 3E Carbon · Revision 2024.01.09