KHS .ACB.RC.2A Bedienungsanleitung Seite 4

KHS e.K.
Gewerbeallee 4
45478 Muelheim / Ruhr
Germany
www.khs.net | info@khs.net
User's Manual | Warranty
KHS RC Alarm Clock
Controls and buttons
1. SNOOZE/LIGHT button
2. Alarm time 1 ON/OFF switch
3. Alarm time 2 ON/OFF switch
4. Time display
5. Date
6. Day of the week
7. Temperature
8. Alarm time 1
9. Alarm time 2
10. SET button
11. UP button
12. DOWN button
13. Alarm button
14. AUTO-LIGHT ON/OFF switch
15. Battery compartment 2xAA (batteries not included)
Time setting
a. In Standard mode, press and hold the „SET" button for 2 seconds to enter the time setting mode.
The digits to be changed will blink. Press the „UP" or „DOWN" buttons to adjust the value.
b. Setting sequence: DST ON/OFF; 12-/24-hour; Time zone; Hour; Minute; MD/DM; Year; Month; Day;
Language (English, Italian, French, Dutch, Spanish, Danish, German); Exit.
c. Press „SET" or do not press any button for 10 seconds to save the settings.
d. Press „UP" once to move forward one step; press and hold the button for 2 seconds to advance at
a rate of 8 steps per second.
e. Press „DOWN" once to move backward one step; press and hold the button for 2 seconds to go
back at a rate of 8 steps per second.
Alarm setting
a. In standard mode, press and hold the „ALARM" button for 2 seconds to access the alarm settings.
The digits to be adjusted will blink. Press the „UP" or „DOWN" buttons to change the value.
b. Setting sequence: Alarm 1 hour; Alarm 1 minute; Alarm 2 hour; Alarm 2 minute; Exit.
c. Use the ON/OFF switch for Alarm 1 and Alarm 2 to turn each alarm on or off.
d. When the alarm sounds, press the „SNOOZE/LIGHT" button to activate snooze mode.
Automatic Light Function
Press „AUTO LIGHT ON/OFF" to activate the automatic light function.
When the automatic light function is enabled, the backlight will automatically turn on in
darkness.
RCC
Press and hold the „DOWN" button for 2 seconds to manually receive the RCC signal.
The radio-controlled clock automatically receives the RCC signal daily at 1:00, 2:00, 3:00,
4:00, and 5:00 AM.
While receiving an RCC signal, the antenna tower icon will blink. If the reception is success-
ful, the antenna tower icon will be displayed. In DST mode (Daylight Saving Time), this icon
will also be shown.
DST
Most countries observe Daylight Saving Time (DST).
To turn DST on or off, press and hold the „SET" button to enter the setting mode. You will
see „ON" blinking. „ON" indicates that the DST function is enabled. Press „UP" or „DOWN" to
disable the DST function. When DST is enabled, the radio-controlled clock automatically
updates the time to adjust for Daylight Saving Time.
Note: If the time display is off by one hour, ensure that the time zone and DST settings are
correct.
Page 1