Herunterladen Diese Seite drucken

Intex HT30220-1 Benutzerhandbuch Seite 6

Vorschau ausblenden Andere Handbücher für HT30220-1:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 38
The appliance is ready to work under the following conditions:
FREE CHLORINE (HCIO + CIO - +CI
pH
CHLORIDES
ISOCYANIC ACID
CALCIUM HARDNESS
BROMIDE (HBrO)
IMPORTANT: The electrical pool heater must be installed as the last piece of pool
equipment before the saltwater pool or chlorine generator system in the water return
line to the pool.
1.
Assemble the above-ground-pool (AGP) and its filter pump per installation instructions.
2.
Remove the electrical pool heater and it's accessories from the packaging.
3.
Place the electrical pool heater in line after the filter pump.
4.
Connect the hose (1) to the electrical pool heater inlet.
5.
If your above-ground-pool is filled up with water, unscrew the strainer grids from the
strainer connectors and insert the black hat-like plugs into the strainer connectors
before electrical pool heater installation. Go to step 6 directly if your pool is empty.
6.
Disconnect the water return (to the pool) hose from the filter pump connection, and
connect it to the upper electric pool heater connection with a hose clamp.
7.
Connect the second hose to the lower electric pool heater connection and to the
lower pump connection. Make sure all the hose clamps (2) are tight.
8.
If applicable, return strainer grids to strainer connectors inside pool after removing
black hat-like plugs that prevented water from flowing out of the pool.
9.
Connect the electric pool heater to the power outlet. Test RCD as shown on following
page.
10. Turn pump on. Check water is flowing through the heater. Then turn heater on.
ELECTRIC POOL
HEATER
If the heater is not in an upright position a safety switch will automatically turn
the heater off. Be sure the heater is always in an upright position while the cord
is connected to the power outlet.
Filter pump must be operating before turning on heater.
S AVE THESE INSTRUCTIONS
(114IO) ELECTRIC POOL HEATER ENGLISH 4.875" X 7.25" PANTONE 295U 04/23/2023
SET UP INSTRUCTIONS
)
2
WATER TO POOL
IMPORTANT
Page 6
up to 3 ppm
6.8 - 8.0
up to 3500 ppm
up to 100 ppm
up to 500 ppm
up to 8 ppm
WATER FROM POOL
FILTER PUMP
114
A

Werbung

loading

Verwandte Produkte für Intex HT30220-1