WARMZONE ETOG-55 Kurzanleitung
Quicklinks
INSTRUCTIONS
ETOG-55 Installation In Asphalt Applications
57736 06/09 - (DJU)
How to install
the ETOG-55
sensor
melting systems in asphalt drive- or walk-
ways.
1 = ET02-4550
2 = Junction box (only necessary if sensor cable
is too short)
3
Metal conduit
for sensor
cable
4 = Heating cable
5 = ETOG-55
sensor
6 = Installation metal bracket plate
7 = Sensor
cable
Cross
section:
This drawing shows cross section Of ETOG-55
sensor installation:
8 = Soft wood
block
9 = Asphalt
10 = Grit
11 = Earth
When the asphalt has cooled off the wood
block should
be removed.
8 = soft wood
block
for snow
WARMZONE-.—
8
Inhaltszusammenfassung für WARMZONE ETOG-55
- Seite 1 5 = ETOG-55 sensor 6 = Installation metal bracket plate 7 = Sensor cable Cross section: This drawing shows cross section Of ETOG-55 sensor installation: 8 = Soft wood block 9 = Asphalt 10 = Grit 11 = Earth When the asphalt has cooled off the wood block should be removed.
- Seite 2 When the wood block is removed the ETOG-55 sensor can be placed in the hole in the asphalt lane. Push the sensor cable through the metal pipe, and place the sensor in the hole. When the sensor is placed in the hole, the...
- Seite 3 WARMZONE-.- INSTRUCTIONS Dansk English Deutsch Nedstøbnings føler type ETOG-55 Ground sensor type ETOG-55 Eingussfühler Typ ETOG-55 Designed forerr{bedding into the Designet for montering i udendørs areal. Der Fühler ist für den Einguss in der Detekterer både temperatur and fugt. surface of the outdoor area.