ENVILAR 2CH-ZG-BOX-RELAY Bedienungsanleitung

ENVILAR 2CH-ZG-BOX-RELAY
EAN: 5712716078543
Safety & Warnings
DO NOT install with power applied to device.
DO NOT expose the device to moisture.
Must be installed by certified electrician.
Connection diagram
2 Channel switch input, to
control 2 channels load
seperatly
Bradico.com
"Reset" key: for network
pairing, touchlink, factory
reset of the switch
2 channels load output
Productdata
Compatible Load
LED indicator: stays off if
the device is not added to a
zigbee network, stays solid
on after the device is added
to a network. Same
indication as connected load
Specifications
when commisioning the
device: network pairing,
touchlink, factory reset
AC power input
ZigBee in-wall switch based on latest ZigBee 3.0 protocol
100–240VAC wide input and output
2 channel output, up to 1170W per channel
Input and output with screw terminals
Enables ON/OFF control and direct pairing via Touchlink
Compatible with universal ZigBee gateway products
Can be controlled by universal single-wire push switch
Each channel (2 CH) can be controlled separately by 2
switches
Radio frequency: 2.4GHz
IP rating: IP20