Herunterladen Diese Seite drucken

Nedco CR100 Einbauanleitung

Badezimmer-/wc-ventilator
Verfügbare Sprachen

Verfügbare Sprachen

Manual/ instructions Nedco bathroom / restroom fan CR100
Switch off the power supply before you start.
1. Remove the screws with a Philips screwdriver.
2. Remove the front from the fan.
3. Lead the wiring by means of which the fan should be connected through the opening on the bottom side of the fan.
4. Mount the fan to the wall/ ceiling.
5. Now connect the 2 cords of the wiring to the openings on the screw terminal, according to the following diagram:
Brown/Phase in the left opening
Blue/Zero in the right opening.
Caution, never connect 2 wires to 1 opening!
6. Then you place the front back on the fan.
Then fasten the screws back in the fan.
Your fan is now ready for use. You can now reconnect the power supply.
Nedco BV
Safety conditions
This fan meets all standards and directives imposed by the EU that apply to electrical appliances. This fan should be installed by
a recognised installer. Installing a fan in a room where the ambient temperatures exceed the stated values of 40˚C and in a
room containing a mixture of air and hazardous gases is prohibited. Running the fan when there is a possibility that the fan
blades are damaged or hindered is not desirable. Precautions should be taken so that no backflow can occur of gases into the
room due to open fire and fuel-fired appliances. Prior to installing, the main power supply should be switched off. Accumulated
dirt and grease could eventually lead to short-circuiting, therefore clean the fan at least once every quarter.
Warranty:
The manufacturer guarantees a 24 month life span after the sales date, when used normally. Here, the safety conditions, the
correct handling of transport, storage, installation and use of the fan must be complied with.
When the fan breaks down due to an error in production within this warranty period, the fan will be replaced by a new fan
without any costs. The costs for renewed installation are not compensated. In case of ambiguities in relation to the correct sales
date, the production date shall apply.
| CR120 | CR150
loading

Inhaltszusammenfassung für Nedco CR100

  • Seite 3 | CR120 | CR150 Einbauanleitung Badezimmer-/WC-Ventilator von Nedco CR100 Trennen Sie vor dem Einbau erst die Stromversorgung. 1. Entfernen Sie die Schrauben mit einem Kreuzschlitz-Schraubendreher. 2. Entfernen Sie das Frontstück des Ventilators. 3. Führen Sie die Drähte, mit denen der Ventilator angeschlossen wird, durch die Öffnung unten am Ventilator.

Diese Anleitung auch für:

Cr120Cr150