1. Controller Function Description
6 Battery Chart
4 Speed Chart
3 Speed down -
1 Joystick
1 Joystick : As shown in Figure 1, push the joystick to control the direction and speed of the wheelchair.
When the joystick is facing forward, the chair moves forward; facing backward, the chair moves back
ward; facing left, the chair turns left and moves forward; when you stop operating the joystick in your
hand,the chair stops moving
2 Turn on/ Turn off : Press 1s , it turns on after a beep. Hold down 3s, it turns off after a beep.
3 Speed down - / Speed up + :" +" means speed up," -" indicates deceleration, the maximum speed is
6km/h, the minimum speed is 1.2km/h
4 Speed Chart: When all 5 LED lights are on, it means the maximum speed is reached. When only one LED
is on, it means the lowest speed. The more LED lights are on, the greater the speed.
5 Horn: Press the horn to alarm and release to stop alarming
6 Battery Chart:
Green LED: Indicates full battery status
Yellow LED: Indicates that the battery is half full
Red LED: Indicates that the battery is low and needs to be charged
1: When all the LED lights on the 5 grids of the power meter are on, it means that the power is full
2: When the number of LED lights on the power meter is less, it means that the power is gradually
consumed.Please note:when the number of power LED lights is less than 3 grids (only 2 yellow lights and
one red light left), the remaining power is not much, and we recommend that you charge it in
time.If only the red LED light is on, the battery power is extremely limited.
IV. Using Introduction
8
2 Turn on/ Turn off
5 Horn
3 Speed up +