Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
– Feed the connecting cable through the cable
bushings and cable seal (16).
– N fasten the wall mount with suitable fas-
tening material through the two knock-out
points
a
.
The wall mount includes appropriate knock-
out points
for replacing an older remote
b
control.
... for assembly on concealed switchbox
– feed the connecting cable through the cable
seal (16).
– N fasten the wall mount with the screws
supplied through the knock-out points
appropriate to the switchboxes.
I
17
K
7
13
N
a
b
b
c
c
a
2.5.3 Remote control electrical connection
– Strip the connecting cable for 35 mm and
insulate the cable ends for 6 mm.
– O insert the terminal strip on the connec-
tors in the wall mount lower part and posi-
tion the wall mount upper part in parking
position.
– P fasten the connecting cable to the ter-
minal strip, noting the sequence of terminal
rows (1, 2, 3, 4) in the connection module.
– Slot the wall mount upper part into the lower
part at the top, fold down and screw tight.
c
Information on:
„Environment, recycling, after-sales service
and guarantee" see Instantaneous Water Heater
Operating and Installation Instructions.
2
13
O
Initial Operation
for the qualified installer
For starting up the instantaneous wa-
!
ter heater DHE .. SL(i) with the remote
control FB 1 SL, please note the Instantane-
ous Water Heater Operating and Installation
Instructions:
– „Completion of installation"
– „Initial Operation".
Spare Parts
excerpt from the Parts List
Nomenclature
Cover Panel (1) . . . . . . . . . . . . . . . . .270777
Wall mount (2) . . . . . . . . . . . . . . . . .270778
Connection module (3) . . . . . . . . . . .270779
J
L
P
Order No.
14
M
16
15
7
Werbung
Inhaltsverzeichnis
