Instructions For Use; Before Initial Operation; Inserting/Replacing The Battery - Flex Rfe 40 18.0-Ec Originalbetriebsanleitung

RFE 40 18.0-EC

Instructions for use

WARNING!
Before carrying out any work on the power
tool, remove the battery.

Before initial operation

Unpack the power tool and accessories and
check that no parts are missing or were
damaged during transport.
NOTE
The batteries are not fully charged on
delivery. Charge the batteries fully before
using for the first time. Consult the charger
operating manual for this purpose.

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts - explosion
and fire hazard!
Battery state of charge
 Press the button to check the state of
charge on the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after
the button is pressed, the battery is faulty and
must be replaced.
Inserting and changing the
reversible blade
CAUTION!
Do not hold the reversible blade by the
edges. Danger of flesh wounds!
The chaser head has 4 reversible blades.
The reversible blades can be turned over.
 Rotate the chaser head until one of the
reversible blades appears in the opening.
 Use the Torx screwdriver to loosen the
screw securing the reversible blade (1.).
 Turn the reversible blade 90° until an
unused side of the blade is aligned in the
chaser (2.).
15