Getting Started - Explore Scientific Rac1001 Bedienungsanleitung

GETTING STARTED

BATTERY
1. Remove the locking pin (1) from the clockwork. The
clock can be operated only after the pin has been
removed.
2. 1x AA (LR6)/1.5V batteries is already installed.
Please remove the insulating strip from the battery
compartment.
CLOCK
CLOCK RECEPTION
After the clock received the DCF time signal the time will
be set according to the Central European time (CET).
Summer and winter time change (and reverse) is also set
automatically. Other deviating times can be set manually
only.
1. After inserting the battery the time will be set
automatically via DCF signal. This process may take
up to 4 minutes. During this process, the clock hands
will turn several times with interruption until they will
display the right time. Do not move the clock during
the reception process.
NOTE: If the clock fails to set the time, place the clock at
another location. Remove the batteries and reinsert them
after 1 minute.
2. If the device is still not receiving the signal, please
proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold the Manual set button (4) for approx.
3 seconds.
2. When the minutes hand starts moving you can the
set the time manually:
• Press the Manual set button shortly to set the time
in
minutes steps.
• Press and hold the Manual set button to set the time
continuously.
3. Release Manual set button to stop manual setting
and save the time automatically and exit manual
time setting mode.
MOUNTING/POSITIONING
The wall clock can be mounted on walls with the wall
mount (2).
TROUBLESHOOTING
Signals from other household devices, such as door
bells, home security systems and entry controls, may
FR interfere with those of this product and cause
temporarily reception failure. This is normal and does
not affect the general performance of the product.
The transmission of the radio signal will resume once
the interference recedes.
OTHER MALFUNCTIONS
If there is no response from the wall clock by
keystrokes or if any other malfunctions occur perform
the following steps.
NOTE: With this procedure all received data will be
deleted.
1. Press Reset button (5) with a pointed instrument
(e.g. pen).
2. The clock hands will move to their start position
(12:00 a.m.) and the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.
SPECIFICATIONS
Dimensions
247 x 47mm (L x W)
Weight
570 g (Exclude batteries)
Power:
1x AA (LR6) 1.5V battery
EC DECLARATION OF CONFORMITY
Hereby, Folux GmbH declares that the
equipment type with part number: RAC1001/
RAC1002/RAC1003/RAC1004/RAC1005/
RAC1006 is in compliance with Directive: 2014/53/
EU. The full text of the EU declaration of conformity is
available at the following internet address:
https://bit.ly/3fE0WrU
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do not
EN
IT
DE
FR
ES
3