Kinderkraft RAKET Bedienungsanleitung Seite 15

•
Non-rechargeable batteries are not to be recharged.
•
Different types of batteries or new and used batteries are not to be mixed.
• Batteries are to be inserted with the correct polarity (+ and –).
•
Exhausted batteries are to be removed from the toy.
•
The supply terminals are not to be short-circuited.
Technical data
Batteries: 3 x AA 1.5 V (not included)
I Product elements
1. Platform
2. Handlebar
3. Brake
II Installing/Replacing the Scooter Battery
To install or replace the battery, turn the scooter over, use a Phillips screwdriver (not included)
to unscrew the safety cover (Fig. G). Replace the batteries, paying attention to the polarity.
Tighten the safety cover.
II Unfolding the scooter
NOTE! Beware of finger pinches! Be especially careful when unfolding the scooter.
To unfold the scooter, pull the safety flange (4) and lift the handlebar (2) up until you hear a
click (Fig. A, B).
IV Handlebar height adjustment
To adjust the height of the handlebar (2), open the locking clamp (5) (Fig. C). Press the steel
height adjustment button located on the handlebar and pull up or down to set the handlebar
(2) at the desired height (Fig. D). The height adjustment button should fit in one of the three
holes in the frame. After adjusting the height, close the locking clamp (5).
V How to ride the scooter?
To activate the scooter lighting functions, press the button located on the platform (Fig. F). You
can change lighting modes by pressing the button again. To turn the product off, hold down the
button located on the platform.
To start riding, place one foot on the platform (1), grab the handlebars (2) with your hands and
choose the direction of travel. Push off the ground with the other foot to start riding.
VI Braking the scooter
To use the brake, press the rear mudguard (3) (Fig. E) with your left or right foot.
VII Folding the scooter
NOTE! Beware of finger pinches! Be especially careful when folding the scooter.
To fold the scooter, pull up the safety flange (4) and tilt the handlebar (2) towards the frame.
You will hear a click when the handlebar is properly folded and locked.
VIII Cleaning and maintenance
The product should only be cleaned with a damp cloth.
Regular maintenance increases the safety of using the scooter.
•
If the wheels show clear signs of wear, consider replacing them.
•
Modifications other than those specified in the manufacturer's instructions are not
allowed.
•
To renovate bearings, remove them, clean them, and apply the appropriate
amount of grease.
4.
5.
6.
15
Safety flange
Blockade
Imbus