Intermatic TWS-T1CIP66-WH Kurzanleitung

INSTALLATION AND WIRING 1
1
OPERATION AND FUNCTION
150
100 200
50 300
5
LUX
Timer adjustment
7 adjustable steps: 1 / 2 / 4 / 6 / 8 (Hr.), D-D (Dusk to Dawn), I.T. (Intelligent Twilight Mode)
Brightness adjustment
7 adjustable steps: 5 / 50 / 100 / 150 / 200 / 300 (Lux),
Time Delay Mode
Subject to the lux setting, the lighting will automatically switch on and off according to the preset time
delay of 1,2,4,6 or 8 hours.
For example, if the time delay is set to 2 hours, then the lighting will switch on at dusk and switch
automatically off again after 2 hours. Should the preset lux value be exceeded for over 10 minutes then
the lighting will be switched off before the time delay ends.
INTERMATIC INCORPORATED | 1950 Innovation Way, Suite 300 | Libertyville, Illinois 60048 | www.Intermatic.com
2
N N N L L L' L'
Max. Ø15mm power code
6 - 8mm
30 - 35mm
6H
4H 8H
2H D-D
1H I.T.
TIME
(Teach-in function)
TWS-T1CIP66-WH Quick Guide
Intelligent Twilight Switch
TWS-T1CIP66-WH
2a
N N N L
N
L
SWITCHING CAPACITY
LED lamp max
Fluorescent lamp max
Incandescent lamp max
D-D Mode (Dusk to Dawn)
The lighting switches on at dusk as soon as the ambient light is below the preset lux value. The lighting will
remain on until the next morning and automatically turn off when the ambient light is above the preset lux value.
I.T. Mode (Intelligent Twilight)
The lighting switches on at dusk as soon as the ambient light is below the preset lux value and will remain
on for a default of 4 hours before switching off. During the morning the lighting will turn on < 2 hours prior
to dawn to ensure a safe illumination of your surroundings. The I.T. mode will learn from the changes of
daylight hours in different seasons and weather conditions.
(Teach-in Mode)
Switch the lux adjustment to
lighting to automatically turn on. After this setting, immediately attach the front cover and step away to
avoid interference with the ambient brightness measurement of the twilight switch. The lighting will switch
off and the LED indicator will flash for 20 sec when the twilight switch is memorizing the ambient brightness.
Afterward, the LED indicator and the lighting will stay on for 3 sec and then go off. The teach-in process is
complete. The memorized brightness value is accepted as the new threshold switching value.
EN
WARNING Risk of Fire or Electric Shock
• Electrical equipment may only be installed and assembled by a qualified
electrician (DIN VDE 0105 Part 1).
• General safety precautions must be observed, e.g.: Before starting work, switch
off the equipment's power supply and secure against being switched back on.
2b
N N N
L L ' L '
N
L
400W
1400VA
16A, max 2000W
at the present moment of the desired ambient brightness level for your
Scan this QR code to
access the product page
at Intermatic.com for
additional information
L L L ' L '
N
L