half of the drawer width. Finally,drill holes .
Using a center punch for positioning is more convenient .)
(NOTE:
③Install the handle and you're done .
B: HANDLE ON DRAWER FRONT(Center of width and height)
①
①:Measure hole centers of handles,adjust and tighten Sliding Drill Guides .
(Cover unused bushing with tape)
②:Measure the width and height of the drawer .
③:Set Large Stop at half of the drawer height, and set the sliding end stop at
half of the drawer width. Finally,drill holes .
Using a center punch for positioning is more convenient .)
(NOTE:
④:Install the handle, and you're done .
C: KNOB ON DOOR INSTALLATION (Off center of width and height)
①:Place the knob to find a position you like and mark it .
②
①
③
②
4
④
③